Raised Flower bed (1 Tier) Assembly Instructions
Raised%20planter%20photo%202_edited.jpg
Raised flower bed 1 Tier ph1 WM.png

Raised Flower Bed (1 Tier) Assembly Instructions

Preparation

Your parcel should contain

2 x Front/Back boards (with countersunk predrilled)

2 x Side boards 

1 x Screw pack

Tools needed (recommended)

PZ 2 Cross-head screwdriver (or PZ 2 cross-head drill bit and drill)

Assembly Instructions

  • Position one of the front boards against the end of one of the side boards. Using the 4x65mm decking screws provided and a PZ 2 cross-head screwdriver or drill. Place two of the screws into the countersunk holes in the front board and screw through the front board into the end of the side board.

 

  • Position the next side board at the other end of the front board. Place two of the screws into the countersunk holes in the front board and screw through the front board into the end of the side board.

 

  • Position the back board at the other end of the two side boards. Place the remaining four screws into the countersunk holes in the back board and screw through the back board into the end of the side board.