Raised Flower Bed (3 Tier) Assembly Instructions

​

Preparation

Your parcel should contain

​

2 x Front/Back boards (with countersunk predrilled)

2 x Side boards 

1 x Screw pack

​

Tools needed (recommended)

PZ 2 Cross-head screwdriver (or PZ 2 cross-head drill bit and drill)

​

​

Assembly Instructions

​

• Position one of the front boards against the end of one of the side boards. Using the 4x65mm decking screws provided and a PZ 2 cross-head screwdriver or drill. Place six of the screws into the countersunk holes in the front board at one end and screw through the front board into the end of the side board. Making sure the top and outside edge are flush before screwing together. 

​

• Position the next side board at the other end of the front board. Place six of the screws into the countersunk holes in the front boards and screw through the front board into the end of the side boards. Making sure the top and outside edge are flush before screwing together.

​

• ​Position the back boards at the other end of the two side boards. Place the remaining twelve screws into the countersunk holes in the back boards and screw through the back boards into the end of the side boards. Making sure the top and outside edges are flush.

​

​